Lock adapters BMW E36 - stock arms - steel

This component from CNC71 is designed for motorsport use, ensuring high strength, accurate fitment, and reliability under extreme conditions.

The product includes a set of steel adapters specifically for BMW E36, complete with mounting bolts for the factory control arms.

Manufactured using CNC machining, these adapters provide a high-quality finish and a precise fit to both the steering knuckle and pin ends.

Each adapter is protected with a zinc coating for enhanced durability.

Installation requires shortening the steering rod and tie rod end by 1 centimeter while keeping the bodywork intact.

Depending on the wear of the knuckle and casting variations, it may be necessary to shorten the bolt securing the adapter to the knuckle to prevent contact with the shock mounting bracket.

These adapters are designed to fit Meyle ball joints to cone specifications.

Due to varying machining tolerances from different manufacturers, there may be scenarios where the ball joint mounting thread protrudes from the adapter, preventing secure bolting.

In such cases, a washer can be used to space the nut for proper installation.

The minimum inside diameter of the rim to accommodate the adapter is 370mm, and the adapters extend the spacing by 2 cm per side, enabling approximately 55 degrees of steering lock.

The kit includes: - LEFT knuckle adapter (1 piece) - RIGHT knuckle adapter (1 piece) - Fixing bolts (4 pieces)

Assembly instructions are included.

This product is intended for racing use only.

DriftParts is not liable for improper installation or misuse.

For inquiries, please contact info@driftparts.it.